Hank's Crew Fixes Appliances in Powder Springs, GA

Powder Springs, From Downtown to Lost Mountain

• Downtown Powder Springs — older homes and newer townhomes within a short walk of Thurman Springs Park.
• The Silver Comet Trail side — neighborhoods that back up to the trail as it runs through town.
• C.H. James Parkway — subdivisions and apartment communities along the main road through the city.
• Macland Road — family neighborhoods on the way toward Marietta.
• Toward Lost Mountain — larger lots, wooded streets and homes with workshops and detached garages.

Powder Springs has one ZIP code on our list: 30127. Put it in the form and you'll see in seconds that your street is covered.

What Hank's Crew Fixes in Powder Springs

Gas Oven Slow to Light? Look at the Igniter

Here's a complaint that starts small and gets worse. You turn the gas oven on, and nothing happens for a minute, two minutes, sometimes longer. Then it lights with a soft whoomp. Or it never lights at all.

Gas ovens built over the last few decades usually rely on a glow-bar igniter. It heats up until it glows, and the gas valve opens only once enough electrical current flows through it. As the igniter ages, it can still glow bright orange and yet stop drawing enough current to open the valve. That's how you end up with a long wait, a loud light-off, or an oven that stays cold.

What you can do on your own:

• Peek through the broiler drawer or the slot in the oven floor while the oven is trying to light. A glow with no flame after a minute or so points at the igniter.
• Don't keep restarting it. If nothing lights, turn the oven off, crack a window and give it a few minutes before another try.
• A strong gas smell, or one that lingers? Leave the house and call the gas company or 911 from outside.

An igniter is a standard part and a routine repair. My techs test it before replacing it, because a weak gas valve or a control fault can cause the very same delay.

Doors That Drift Open: Level the Fridge First

If your refrigerator door doesn't swing shut on its own, or the freezer drawer creeps open after you close it, the fix may take two minutes and no parts at all.

Refrigerators are meant to sit with the front a touch higher than the back, so gravity helps the doors close. Over the years, or after a move or new flooring, that tilt gets lost.

1. Take off the toe grille at the bottom front.
2. Find the leveling legs or rollers at the front corners. Many turn by hand or with a wrench; some adjust with a screw.
3. Raise the front slightly, about a quarter inch higher than the back.
4. Open the door halfway and let go. It should close gently by itself.

Then try the paper test. Close the door on a sheet of printer paper at several spots around the seal. If the paper slides out with no drag at all, the gasket isn't sealing there. A gasket that's torn, flattened or pulling away from the door lets warm air in around the clock, and the fridge pays for it with longer run times and frost.

Freezers in Workshops and Outbuildings

With bigger lots comes bigger storage. Many Powder Springs homes keep a chest freezer in the workshop or a second fridge in a detached garage. Those spots are rough on appliances: hot in summer, cold in winter, dusty all year and out of sight.

• Give it air. Keep tools, lumber and feed bags a few inches away from the sides and back.
• Vacuum the condenser once or twice a year; sawdust and yard dust pack in fast.
• Skip the extension cord. Plug the freezer straight into its own wall outlet, not a long cord or a circuit shared with power tools.
• Put a thermometer inside and glance at it whenever you walk past.
• Mind the frost on a manual-defrost chest freezer. Once it builds to about a quarter inch, it's time to defrost.

Powder Springs Kitchen Trouble, by the Symptom

• A gas oven that glows but takes minutes to light.
• A refrigerator door that won't close without a push.
• A workshop chest freezer that hums along while the food on top goes soft.
• An ice maker filling the bin with cloudy, stale-tasting cubes.
• A glass cooktop element stuck on high no matter where the knob sits.
• A side-by-side with water pooling under the crisper drawers.

Still Under the Maker's Warranty? Check First

Plenty of homes in and around Powder Springs have appliances that are only a few years old. Before you book any repair, it's worth checking whether the manufacturer's warranty still covers the problem. Find the purchase date along with the model and serial numbers, then look at your paperwork or the manufacturer's website. Some manufacturers cover the sealed system longer than the rest of the appliance.

If the appliance is past that coverage, or you'd rather not wait on a manufacturer's schedule, Hank's crew is ready. Our repairs carry their own warranty of up to 6 months on parts and labor.

How a Mars Visit Goes in Powder Springs

You reach us. By phone or by form. A person is on the line 24/7 and offers a same- or next-day window.

We track down the cause. The tech checks power, gas, water and settings, then tests the parts tied to your symptom. You hear what failed before anything gets replaced.

We repair it. With your approval, genuine or OEM-approved parts go in, and the appliance runs through a full test before the tech heads out. Parts and labor stay covered for up to 6 months.

What Comes Standard in Powder Springs

• Same- or next-day visits in 30127.
• A live person answering the phone 24/7.
• EPA 608 certified techs whenever a job touches refrigerant.
• Background-checked techs and insured work.
• Genuine or OEM-approved parts only.
• A warranty of up to 6 months, labor included.
• Family-owned, with 15+ years in the trade.

Brands We Repair in Powder Springs

In Powder Springs we service Whirlpool, GE, GE Profile, Frigidaire, Maytag, Kenmore, Amana, KitchenAid, Samsung, LG, Electrolux, Bosch and Haier, plus chest and upright freezers of all ages. My techs have put in years of work on each of these brands.

Mars Appliance Repair is independent and family-owned. No manufacturer is connected to us or endorses us; brand names appear here only to show what we work on.

Other Cities Near Powder Springs

• Austell — south, toward I-20
• Marietta — northeast, up Powder Springs Road
• Mableton — southeast, through south Cobb
• Smyrna — east, along the Silver Comet Trail
• Kennesaw — north, across Cobb County
• Acworth — north, toward Lake Allatoona

Our Powder Springs techs set out from 1945 The Exchange SE, Atlanta, GA 30339.

Book Hank's Crew in Powder Springs

Call (470) 516-8711, where a person answers 24/7, or send the form, and we'll line up a same- or next-day visit to your Powder Springs home.